Dc5v Smd5050 60leds Waterproof IP67 LED Rigid Bar Aluminum Case Light Tubes

Features:

1. This LED rigid bar is full addressable so it can be cut every LED.
2. The LED is the most popular chip WS2812, WS2811 chip build inside SMD 5050 RGB.
3.  Aluminum housing with epoxy waterproof IP65, both side of bar output the waterproof 3Pin connector.
4. Every 1 meter bar include 2pcs metal clip(for installation use), 1pcs T type connector(every 5m).
5. PCB Color: White and Black are available, PCB Width: 15mm.
6. Control: SD controller ,DMX Decoder, Artnet,etc.
7. Waterproof, energy-saving, low-cost of maintenance, and long life span.
8. Length: 0.5M, 1M, 1.5M,2M or customized
9. It is very cool for LED signs, whole building decoration,stage.
10. fully addressable ws2811 full color led rigid bar for building
11. cover color: clear cover and milky cover are available
12. Outdoor usage waterproof IP67 with glue
13. ws2811 IC chip built inside RGB LED lamp

Pictures:

 
Instructions:
 
1. Compatible 5V power supply
An LED 5Volt Driver is required to power the LED rigid bars. They are available to buy with the LED bar on this page or can be purchased separately in our LED driver department where we also sell waterproof drivers. Each metre of LED rigid bar requires 14.4 watts of power so choose a driver powerful enough to supply the total watts required.
 
2. Connection:
1) Signal wire: DC+,GND,DAT,
2) DC+ and GND connect to power supply;DAT connect to controller
3) Relative Controller: SPI controller support ws2811; when use DMX decorder, can connect to DMX controller and work with Madrix software
4) Support online control, T-200k can be online /off line controlled
 
3. Installation:
Each light bar is supplied with 2 metal clips - screw the clips to a surface then push the light bar into the clips to secure.
 

Pictures:

 
Note:
1. Indoor and oudoor using 
2. Turn off the power before installment, don't touch the surface of the lights when light on 
3. Please make sure using in the normal environment
4. To avoid using nearby the hot or heat source place,where has the corrosive gas.
5. Make sure the installment place could afford 10 times of the weight of light.
6. Installed position must be no shock, no fire hidden danger
7. Do not touch or/and knock the product body during working
 
Discription:

This led rigid strips will give you an atmosphere of freshness, if used in 

illuminating signs, interior lighting, cove lighting, or exhibit lighting, large 

cabinet lighting, project lighting, and any sort of close application task

 lighting. This led rigid light stripe features Brightness, safety, environmentally-friendliness, long-lasting but also energy saving.