High Brightness Smd5050 Dmx 60led/m LED Rigid Bar waterproof ws2811 full color
 
Features:

1. This LED rigid bar is full addressable so it can be cut every LED.
2. The LED is the most popular chip WS2812, WS2811 chip build inside SMD 5050 RGB.
3.  Aluminum housing with epoxy waterproof IP65, both side of bar output the waterproof 3Pin connector.
4. Every 1 meter bar include 2pcs metal clip(for installation use), 1pcs T type connector(every 5m).
5. PCB Color: White and Black are available, PCB Width: 15mm.
6. Control: SD controller ,DMX Decoder, Artnet,etc.
7. Waterproof, energy-saving, low-cost of maintenance, and long life span.
8. Length: 0.5M, 1M, 1.5M,2M or customized
9. It is very cool for LED signs, whole building decoration,stage.
10. Aluminum  case
11. fully addressable ws2812b full color led rigid bar for building
12. Beam angle: 120degree viewing angle
13. DC 5v input, 3Pin connectors

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Instructions:
 
1. Compatible 5V power supply
An LED 5Volt Driver is required to power the LED rigid bars. They are available to buy with the LED bar on this page or can be purchased separately in our LED driver department where we also sell waterproof drivers. Each metre of LED rigid bar requires 14.4 watts of power so choose a driver powerful enough to supply the total watts required.
 
2. Connection:
1) Signal wire: DC+,GND,DAT,
2) DC+ and GND connect to power supply;DAT connect to controller
3) Relative Controller: SPI controller support LPD6803; when use DMX decorder, can connect to DMX system
4) Support online control
 
3. Installation:
Each light bar is supplied with 2 metal clips - screw the clips to a surface then push the light bar into the clips to secure.
 
4. CE and ROHS approved to comply with Europe safety regulations.

Pictures:

 
Note:
1. Indoor and oudoor using 
2. Turn off the power before installment, don't touch the surface of the lights when light on 
3. Please make sure using in the normal environment
4. To avoid using nearby the hot or heat source place,where has the corrosive gas.
5. Make sure the installment place could afford 10 times of the weight of light.
6. Installed position must be no shock, no fire hidden danger
7. Do not touch or/and knock the product body during working
 
Trade Term:
 

 Mr. Tom Lee

Tel: 86-755-23125058

Contact to this supplier